AUTHORIZED DISTRIBUTOR INDONESIA
PRODUCTS
We are providing best services for insulation refurbishment replacing rockwool to new insulation technology using ceramic material which perform excellently in preventing corrosion under insulation (CUI) Apart from that, we have several products to prevent corrosion in various environment: wet area, humidity surface, up until acidic environment.
RUST GRIP
Seal off corrosion for any environment
BENEFITS
- minimally prepared surfaces – ie. No sandblasting!
- Extremely tough, UV-controlled and is not affected by hostile environments
- Designed to withstand acids, salts and caustics with no loss of strength (submergible in 100% nitric acid without any effects)
- can be applied directly over rusted surfaces after loose material is removed
- Can be used as a moisture protective membrane to stop moisture penetration, contaminants, mould and mildew.
MOIST METAL GRIP
anti-corrosion for wet or submerged surfaces
BENEFITS
- Prevents corrosion of coated materials from the damaging effects of submersion or constant moisture exposure
- Can be applied directly to wet or condensed surfaces
- Can withstand temperatures up to 149°C and has been tested to 450 hour salt spray exposure
- Can be used on all metal, wood and concrete surfaces that are exposed to constant water pooling or condensation
- Flexible and durable in even extreme conditions
ENAMO GRIP
top coat for almost any surface in even the toughest environments
BENEFITS
- Protects against UV, wear, weathering, and moisture penetration. seals against moisture/gases and protect against acid/solvent contact.
- Can be used as a top coat for pipes, tanks, vehicles, equipment and facilities to give a smooth, even finish to vehicles and equipment
- Resistant to hail damage and similar abuses that create opportunities for rust and corrosion, exceptional graffiti resistance, and resist the permanent damage of vandalism.
- It is submergible – water resistant
SUPERTHERM
Block heat-load, moisture-penetration, and air infiltration on virtually any type of surface
BENEFITS
- Drastically reduces the energy consumption required from your cooling/heating unit by keeping the heat out during summer.
- Blocks moisture and air infiltration prevent the development of mould, mildew and wood rot.
- Is only 0.254 mm thick can replace 15-20 cm of traditional insulation in some conditions, it is a Cool Roof product.
- It is a single component ready-to-use and easy-to-apply coating, water based, non-toxic and environmentally friendly, and UV and weather resistant
- It is a single component ready-to-use and easy-to-apply coating, a Class A0 Fire Rating, and prolong the lifespan of your material and equipment for up to 20 years
HOT PIPE COATING
Designed to control heat transfer on surface temperatures up to 250°C
BENEFITS
- Can be used to block conductive, convective and radiational heat. It is an insulation system over hot pipes, tanks, and valves
- It is easy-to-apply directly on to hot pipes while pipes are still operational, when a hot system cannot be shut down
- Can be sprayed to fit over any configuration or shape, making it possible to reach the most difficult places in highly complex environments
- It is long lasting, a safe, non-flammable and non-toxic solution, prevent corrosion under insulation (CUI).
- Has been successfully tried and tested throughout the world
HOT PIPE COATING HT
Application directly over surfaces minimum temps of 250°C and up to 600°C
BENEFITS
- As the high-temp insulation coat for surfaces greater than 250°C, over hot pipes, tanks, and valves
- To hold heat on the surface of the pipe, valve, etc.
- As a system to block conductive and convective heat transfer
- Applied when a hot system cannot be shut down.
- It is a two-part hybrid silicone/solvent resin, designed to block and hold the interior temperature on the surface and reduce heat transfer loss to ambient.
- A ‘green’, nonflammable, non-toxic formula for high-heat surface applications.